Team:Yale/Project Bioassay

From 2013.igem.org

Revision as of 16:29, 24 September 2013

Return to iGEM main page

• Home
• Team
• Official Team Profile
• Project
• Parts Submitted to the Registry
• Modeling
• Notebook
• Outreach
• Safety
• Attributions

Develop bioassay to screen PLA production

• We needed a way to detect the PLA once we produced it using the heterologous enzymes
  • We decided to use the fluorescent dye Nile red, a intercellular lipid strain
  • Nile red does not affect the growth of bacteria, and its fluorescence is quenched in water

This is a figure from Spiekermann et al. 1996 demonstrating Nile red staining of both PHB+ E. coli and PHB negative E. coli

Positive Control

• We used the 2012 Tokyo Tech Biobrick (BBa_K934001) as a positive control to attempt to detect Nile red fluorescence on our plate reader (ex. 530nm, em. 590nm)
  • This plasmid had three enzymes which together give E. coli that ability to synthesize P(3HB) a similar plastic PLA
  • Cells were grown for 24 hours in the presence of Nile red. The cells were washed and resuspended in PBS.

Our Construct

• We then proceeded to test our plasmid in the plate reader.
  • Cells were grown for 24 hours with both enzymes induced and in the presence of Nile red. The cells were washed and re-suspended in PBS. The readings were normalized for optical density.

FACS Sorting

• In order to quickly screen the large diversity created using MAGE, we employed Fluorescence-activated cell sorting (FACS)
  • FACS could sort cells based on the Nile red fluorescence, thus indicating those cells that have produced larger quantities of PLA

Testing for PLA

• Nile red has an emission maximum at 598nm when bound to p(3HB) granules according to Spiekermann et al. 1998
• Thus we decided to use PE-Texas Red which has an emission maximum at 615nm in order pick the best colonies.
  • PE-Texas Red is a covalently linked fluorochrome used as the detector. The FACS machine measure the emission of this fluorochrome because Nile Red is not a common fluorochrome that a FACS machine would have detector specific to Nile red.

The left graph shows the distribution of cells entering the FACS. A gate is made to only focus on those which are relatively round and average size (the enclosed red shape). The right graph is the fluorescence of those selected cells. A gate (labeled P2) is made and 1/10,000 of the cells are within this gate. Ideally we would want the machine to select only those with fluorescence above the control cells (and thus no control cells in the P2 gate) but we believe this one cells is an outlier due to its abnormally high levels of fluorescence.

This is the experimental sample. The same gate is applied to attempt to sort the desired cells (those with higher levels of Nile red fluorescence) compared to the control. These 7/10,000 cells were sorted and a culture was made in a matter of minutes.

• Next we tested these FACS sorted cells on the plate reader to see if we could detect a difference from the FACS sorted and non-FACS sorted cells
  
  

• This graph demonstrates that our FACS bioassay method was successful in selecting for cells that exhibit higher levels of PLA-induced fluorescence.