Team:SJTU-BioX-Shanghai/DIY/make

From 2013.igem.org

(Difference between revisions)
(How to make the box?)
(How to make the box?)
 
(5 intermediate revisions not shown)
Line 6: Line 6:
<!----------------------------------------------------从这里开始写wiki--------------------------------->
<!----------------------------------------------------从这里开始写wiki--------------------------------->
=='''How to make the box?'''==
=='''How to make the box?'''==
 +
[https://2013.igem.org/Team:SJTU-BioX-Shanghai/DIY/use How to assemble the box?]<br>
 +
[https://2013.igem.org/Team:SJTU-BioX-Shanghai/DIY/family Family Portrait!]
<br>
<br>
First of all, we custom-make a empty wooden box without head cover and bottom and carve it by hammer and knife.  
First of all, we custom-make a empty wooden box without head cover and bottom and carve it by hammer and knife.  
Line 11: Line 13:
<br><br>
<br><br>
In order to separate our dark box into different independent grids, we make a 16 cells barrier by 6 tagboards' assembly.
In order to separate our dark box into different independent grids, we make a 16 cells barrier by 6 tagboards' assembly.
-
[[File:13sjtu_make2.jpg|600px]][[File:13sjtu_make3.jpg|600px]]
+
[[File:13sjtu_make2.jpg|550px]][[File:13sjtu_make3.jpg|550px]]
<br><br>
<br><br>
Then we need a head cover which has 48 holes matched with the barrier so that we can insert 3 test tubes into each cell.
Then we need a head cover which has 48 holes matched with the barrier so that we can insert 3 test tubes into each cell.
-
[[File:13sjtu_make4.jpg|600px]][[File:13sjtu_make5.jpg|600px]]
+
[[File:13sjtu_make4.jpg|550px]][[File:13sjtu_make5.jpg|550px]]
<br><br>
<br><br>
Last we should weld small electronic components onto our PCB and revise them so that they can output linear light under linear electric current.
Last we should weld small electronic components onto our PCB and revise them so that they can output linear light under linear electric current.

Latest revision as of 03:24, 29 October 2013

How to make the box?

How to assemble the box?
Family Portrait!
First of all, we custom-make a empty wooden box without head cover and bottom and carve it by hammer and knife. 13sjtu make1.jpg

In order to separate our dark box into different independent grids, we make a 16 cells barrier by 6 tagboards' assembly. 13sjtu make2.jpg13sjtu make3.jpg

Then we need a head cover which has 48 holes matched with the barrier so that we can insert 3 test tubes into each cell. 13sjtu make4.jpg13sjtu make5.jpg

Last we should weld small electronic components onto our PCB and revise them so that they can output linear light under linear electric current. 13sjtu make6.jpg

Thus we have all of our assembly parts well prepared!

13sjtu make7.jpg