"
Team:DTU-Denmark/Methods/Autoclaving
From 2013.igem.org
(Difference between revisions)
(→Autoclaving in the lab of DTU building 208) |
|||
| (One intermediate revision not shown) | |||
| Line 5: | Line 5: | ||
==Autoclaving in the lab of DTU building 208== | ==Autoclaving in the lab of DTU building 208== | ||
| - | * | + | *Close the lid |
| - | * | + | *Check if it is locked (the orange pointer should be turned vertical) |
*Wait until the condensation goes out before closing the valve | *Wait until the condensation goes out before closing the valve | ||
| - | *Let temperature reach 125 C and pressure 20 psi | + | *Let temperature reach 125 <sup>o</sup>C and pressure 20 psi |
| - | * | + | *Wait for 15 min before switching off the power and wait an hour. |
</div> | </div> | ||
Latest revision as of 18:00, 4 October 2013
Autoclaving
Autoclaving in the lab of DTU building 208
- Close the lid
- Check if it is locked (the orange pointer should be turned vertical)
- Wait until the condensation goes out before closing the valve
- Let temperature reach 125 oC and pressure 20 psi
- Wait for 15 min before switching off the power and wait an hour.
