Team:Buenos Aires/ model

From 2013.igem.org

(Difference between revisions)
(Deterministic Model)
Line 19: Line 19:
====Arsenic promoter + ArsR + RFP====
====Arsenic promoter + ArsR + RFP====
 +
First we tried to keep it as simple as we could. Figure 1 shows our first design which, in theory, produces different responses to different concentrations of arsenic in water. Figure 2 shows a simulation graphing the time series response of the Pars-arsR promoter for different concentrations of ars. One may, we did,

Revision as of 03:02, 25 September 2013


Contents

Deterministic Model

Introduction

Our objective was to assemble a system that could respond to different concentrations of a specific contaminant in water. More specifically, the idea was to produce different amounts of a coloured pigment depending on the concentration of the contaminant present in water.

We worked with Arsenic knowing that an arsenic detoxification operon (Ars operon) exist in nature and more important, it exists as biobricks.


Got Ideas?

For our biosensor we came up with three different designs each one motivated on improving the flaws detected while analysing the previous ones using mathematical models as our main tools. We describe briefly the first two designs which were later rejected to emphasize the importance of mathematical model to gain insight on how our system works and as a feasibility study.

Arsenic promoter + ArsR + RFP

First we tried to keep it as simple as we could. Figure 1 shows our first design which, in theory, produces different responses to different concentrations of arsenic in water. Figure 2 shows a simulation graphing the time series response of the Pars-arsR promoter for different concentrations of ars. One may, we did,


Unfortunately

Rfp en el tiempo.jpg

As it is shown in the figure below, in the presence of arsenite (1000 ppb) a typical transcriptional induction is observed over time. There is a lag of 3 hours in the mRFP produciton after adding arsenite.

mRFP stability over time