"

From 2013.igem.org

Contents 1 Results from the transformation plates 2 Digestion of pSB1C3 backbone 3 Circularisation of pSB1C3 4 Gel Electrophoresis

Results from the transformation plates

• On the 01/08/2013 we plated the transformations containing the biobrick BBa_K118025.
  • Our transformations were successful

• the plates contained different volumes of the transformation: 20ul and 200ul
• the plate to test viability shows growth as expected
• the plate to test resistance shows no growth as expected
• there were two different different transformations that contained different volumes of ligated DNA, which were plated into different plates.

• The 10ul ligated DNA plates showed growth

• The 5ul ligated DNA plates showed growth

• The RFP control plates showed growth as expected
• the plates with the ligated DNA did not show growth as the RFP plates, this could be because the cells did not take up as much plasmid as the optimum RFP plasmid or not all the plasmid were ligated with the biobrick.
• It is also important to notice that there is not much different in the number of colonies between the 5ul and 10ul plates.

Digestion of pSB1C3 backbone

• Master Mix (changes were made from the protocol)
  • 5ul cut smart Buffer
  • 0.5ul of XbaI
  • 0.5ul of SpeI
  • 19ul of dH2O
• For each reaction add:
  • 4ul of linearized backbone
  • 4ul of enzyme master mix
• digest at 37C for 30min
• heat kill at 80C for 20min
• this digestion was done as control to test if our colonies with the limonene biobrick is expressing limonene.

Circularisation of pSB1C3

• For this experiment, two separate samples will be run; a control and the actual ligation.
• Add the following substances
  • 12ul of dH2O
  • 1ul of QS Ligase*
  • 2ul of the digested vector pSB1C3
  • 5ul of 4xQS Buffer (vortex before use)
  • Mix thoroughly by pipetting
• Incubate at room temperature for 5 min to create cohesive ends
• Run 2.5-5ul of the ligation mixture onto an agarose gel to check ligation efficiency against a known marker. Add 5ul of dye to aid the visualization of results.
• Transform it into competent cells (E.coli)

*For the control, no QS Ligase is added but its equivalent volume (1ul) is made up by dH2O.

Gel Electrophoresis

• Gel was run in order to confirm that the cirularisation experiment had worked.
• The linearised pSB1C3 vector was used as a control.

The results below show that the circularisation experiment worked, as the linearised vector is represented on the gel while the circularised vector was cloudy and ran off the gel.