Team:UGA-Georgia/Results

From 2013.igem.org

Revision as of 18:23, 27 September 2013 by Mwestb1 (Talk | contribs)

Geraniol Production

Geraniol standard 73013.png
Sample 7 73013 (2).png
Sample 6 73013.png
Mass Spec Sample 6 73013.png
Geraniol standard 9613 (2).png
Geraniol sample 9613.png






(1) This chromatograph is from a geraniol standard we created and ran on 07/30/2013. The substantial peak in this chromatograph is geraniol.











(2) This chromatograph is of one of our samples that we extracted geraniol from. The significant peak with similar retention time to the standard is geraniol. This was confirmed using Mass Spec.











(3) This chromatograph is of another one of our samples. The significant peak with similar retention time to the standard is geraniol. This was confirmed using Mass Spec (see image below).












(4) This Mass Spec analysis of the previous sample recognizes the significant peak at 7.81 minutes as geraniol (aka trans-3,7-dimethyl-2,7-octadien-1-ol)












(5) This chromatograph is of a geraniol standard we created and ran on 09/06/2013. The significant peak here was confirmed via Mass Spec as geraniol (see window in top corner of image).







(6) This chromatograph is of a pAW42-GS sample that we extracted geraniol from. The significant peak here with similar retention time to the standard was confirmed as geraniol via Mass Spec (see window in bottom corner of graph)





Conclusion:

We created geraniol standards of different concentrations and plotted the concentration of the standard against the integral area of the peak formed in the respective chromatograph. From here we were able to draw a regression line through the data points and obtain a linear function. We used this linear function to accurately calculate the amount of geraniol produced in our samples. So, we can conclude the production of geraniol as over 0.2% of the DLW in Methanococcus.

BioBrick Tools

V2V4gel.png
Biobrick v2v4.png
V4fluorescence.png

Screening Strategy: Acc65I & PstI

Positive=3133,1446,367

Negative:3143, 1725


L1- BBa_k1138001A

L2- BBa-k1138001B

L3- BBa-k1138001C

L4- Blank

L5- BBa-k1138002A

L6- BBa-k1138002B

L7- Blank

L8- BBa-k1138002C

L9- Ladder


Analysis and conclusion

From lanes 1-8 it is seen that all are positive.








These are the two tools that we created that will allow you to regulate and quantify gene expression. One has an RBS and the other one does not. The one with the RBS can be used as a control and the one without can be used to insert your gene of interest to quantify expression. Both tools have EcoRI, NotI, XbaI, and NsiI restriction sites for insertion of a gene.










This graph shows the fluorescence of BBa-k1138002 in comparison to the Methanococcus wild type strain s0001. We report the fluorescence in our BioBrick part roughly as a 3 fold increase. Note that the wild type gives a small fluorescence reading due to the fact that Methanococcus is naturally bio-luminescent.








Conclusion:

We have shown that our tool fluoresces around 3 times more than normal Methanococcus making it a valuable tool for quantifying and regulating gene expression. We hope that future researchers and iGEM teams will use this tool in the future to use methanogens as an organism for synthetic biology.