"
The final aim is to control our bacterial population with only one data available : the global fluorescence. But in the experiments, in order to prove that our system works, besides the fluorescence we measured the $OD_{600}$ and the amount of living cells.
At first, we wanted to have a constant population of living bacteria, therefore an $OD_{600}$ going up in a linear way. The model was necessary to find what would be the best illumination to provide to have as quickly as possible a stable level of the amount of living bacteria.
A Model Predictive Control is a Process Control able to deal with complex systems like ours. The aim is to drive our system to a setpoint, to do so, it will use different kinds of variables:
$\bullet$ Some variables defines the setpoint, here, we want to drive our living bacteria concentration to a determinate value.
$\bullet$ Some variables are measurable durong the experiment, here, the fluorescence. They are the only ones that will enable us to see if the system behaves according to plans.
$\bullet$ Other cannont be measured and have to be estimated with the model. Precisely, the living bacteria concentration cannot be measured. This is a reason why the model has to be precise : we will not be able to measure our setpoint, it shall be estimated.
$\bullet$ And variables are the ones used to act on the system. The light intensity wi
When the model's parameters were calculated, it appeared that some of them ($b$, $k$ and $l$) were very variable, their value depended a lot on the preparation of the experiment. Sadly, it is important that they are the more accurate possible, the quality of the predictions depend greatly on them. That is the reason why those 3 parameters shall be slightly modified for each experiment.
