Team:NTNU-Trondheim/Model

From 2013.igem.org

Revision as of 12:37, 4 October 2013 by Eivnd (Talk | contribs)

Trondheim iGEM 2013

header
Mercury
Modelling of the Pm/Xyls Promotor system



The Pm/Xyls promotor system is a positive regulator system where the regulator molcule, Xyls, is constitutivly produced. When Xyls binds to the inducer m-toluic acid this complex binds to the Pm promotor(see figure 1). Binding to the promotor facilitates binding of RNA polymerase (RNAp) making it active (RNApA). This starts production of mRNA in an elongation step. The mRNA will be translated into the recombinant protein, or in our case, RFP. Over time mRNA and RFP will be degraded to som extent.



Figure: Overview of how the Pm/Xyls Promotor system funtions. Production of recombinant protein is dependent on access to the indicer m-toluic acid.


The reaction equations in the Pm/Xyls promotor system are listed below. The degradation of mRNA and RFP will inhibit an exponential production of these and after time the levels of mRNA and RFP will stabilize around a steady state.



Figure:


A deterministic simulation of the system was run on Cain software with the parameters as viewed in figure 2. Only the number/consentration of the inducer was varieted. A .zip file with all of the modeling files can be downloaded [[Media:NTNU_Trondheim_modelingfiles.zip|here]]. The csv files are named according to the number of inducer that was applied in the deterministic simulation.

Figure 2: Overview of parameters applied in the Cain program


The labels of the species (reaction molecules) are as follow: XLS = Xyls, inducer = m-toluic acid, XLSinducer = complex of XylS and m-toluic acid, DNA = plasmic DNA, XDNA = Binding of XLSindicer to the DNA, RNAp = RNA polymerase, RNApa = active RNA polymerase, E = elongation, RFP = red fluorescent protein.

Results



Varies starter consentration of inducer (0, 0.06, 0.3, 0.6, 1.2 and 6 µM) gave the result as indicated in figure 3 and the table below.

Figure 3: Different consentrations of inducer (0 to 6 uM) was applyed in the deterministic simulations, yeilding different amounts of RFP.


Start consentration (µM) of inducer Molecules of inducer Consentration (µM) of RFP (steady state) Molcules of RFP (steady state)
0 0 0 0
0.06 100 0.51 850
0.3 500 0.63 1050
0.6 1000 0.66 1100
1.2 2000 0.68 1135
6.0 10 000 0.71 1180
As the levels of indicer increases, the steady state of the protein product increases up until it reaches 1200 molcules. An huge increase in inducer over 10 000 molecules will not give a RFP steady state of over 1200. The steady state is determined by the rates K4, K5, D1 and D2. A key discovery in doing the modeling of this system is that the follwing statments are crucial: K1


Retrieved from "http://2013.igem.org/Team:NTNU-Trondheim/Model"