Team:Paris Bettencourt/Project/Sabotage

From 2013.igem.org

(Difference between revisions)
Line 33: Line 33:
       <p>Our objective is to make an antibiotic-resistant bacterial population sensitive again to those same antibiotics.</p>
       <p>Our objective is to make an antibiotic-resistant bacterial population sensitive again to those same antibiotics.</p>
     </div>
     </div>
-
  </div>
 
     <a href="#Design">
     <a href="#Design">
     <div class="hlink">
     <div class="hlink">

Revision as of 22:34, 4 October 2013

Background

One of the main concern about tuberculosis today is the emergence of antibiotic resistant strain

Results

  • Construction and characterization of phagemids coding for small RNA targeting antibiotic resistance proteins
  • successful conversion of antibiotic resistant population of E. coli to a sensitive state

Aims

Our objective is to make an antibiotic-resistant bacterial population sensitive again to those same antibiotics.

Introduction

   As resistance against antibiotics are growing and pharmaceutical pipelines are drying up, we decided to investigate a new strategy based on specific silencing of the genes responsible for resistance through bioengineered stealth bacteriophages. The silencing of the genes is obtained with a simple and modular system of tailormade small RNAs and the spreading of this construct in a bacterial population is based on an autonomous phagemid/helper phage system. We demonstrated the validity of this trojan horse strategy by converting back to a sensitive state populations of bacteria initially resistant to antibiotics like chloramphenicol or kanamycin.

Figure 1. The Trojan Horse Strategy : Infecting the cells with a phage bearing a sRNA silencing the expression of antibiotic resistant genes converting it back to a sensitive state.

Design

   Design a silencing device

We choose a straight forward strategy to force bacteria to stop producing those proteins by targeting the mRNA coding for those proteins with tailormade small RNAs.In order to design our silencing device (small RNA) we used the protocol described in Na et al 2013 and inserted a 24bp sequence complementary to the RBS area of the target genes inside the scaffold sequence that allow the stabilization of the hybridization. We designed three sRNA respectively targeting Kanamycine resistance gene of Duet Vector (pCOLA), Chloramphenicol ones (pACYc) and lac Z

.

Figure 2. The sRNA anti-Cm

   Design a genetic element that spread in a population
In nature, non-lytic filamentous bacteriophages are quite good at spreading genetic elements in bacterial populations and we thus imediately thought about them as vectors of choice. However being infected by a phage represent a huge burden for an individual bacteria which we thought would be detrimental for our construct to be able to maintain itself long enough in a population for this system to be clinically relevant.

Therefore we choose to use a phagemid/helper system which is composed of two mobile interacting elements. The « heavy » elements of this system is an M13 phage which genome contains an altered packaging signal thus reducing the probability of packaging in a protein capside and escaping from the cell. Its role is to produce capside proteins which will in fact be used by a « light » element called phagemid which is a normal plasmid harboring a packaging signal.

  
As a result a cell containing both elements will produce and secrete a lot of phagemid encapsulated plus some helper phages from time to time. We expect such a system to infect with light elements the majority of cells in a population and to be able to spread and maintain itself thanks to a small number of coinfected cells harboring both light (phagemid) and heavy (helper phage) elements transforming them into phage-producing cells.

Our silencing device is loaded on the light element in order to spread it efficiently. As the post-transcriptional regulation we are using only rely on RNA and doesn’t require synthesis of any protein, its cost for the cell will be very low. Moreover producing protective proteins against antibiotics is costly for the cell and lower its fitness in an antibiotic free environment, we thus expect our silencing device to be a temporary relief for the infected cell which should avoid early counterselection dynamics


  



Design of a sequential killing strategy
To perform our proof of concept experiments, our targeted genes were different antibiotic resistance genes on commercial plasmids that were transformed in MG1655 cells. This model of plasmid bearing resistance was chosen because it was more close to real life situation. Indeed resitance genes are mostly located on plasmids. The experimental set up consisted of a sequential strategy ; a phage infection followed by a treatment with antibiotics. The phage infection leads to the silencing of the antibiotic-resistance genes. After the silencing is complete, antibiotics are used to kill the cells to prove the efficiency of the silencing and the possibility of using this strategy as a therapy.


Figure 3. A sequential killing strategy :
From a overnight culture of Chloramphenicol resistant cells (MG1665 + pACYc Duet Vector), different sample of cells were grown to OD 0,7, and infected (or not) with sRNA phages ( isolated from supernatant from overnight culture of cells producing phages) with a volume ratio of phage vs cells of 1to a 100). The mix was incubated at 37°C for 45 minutes. Appropriate dilutions were then plated on Chloramphenicol plates and LB plates. Colonies were screened after overnight incubation at 37°C.

Characterization of the phagemid system

   We received the phagemid Helper system used in this project from Monica Ortiz. it consists of a helper plasmid, M13K07 bearing Kanamycine resistance and a phagemid, Litmus-28 bearing GFP and a Ampiciline resistance. Using those different markers, we characterized the system by infecting the cells with a ratio of phage of 1 to 100 and plating appropriate dilutions on different medias (LB,Kan, Amp, Kan/Amp). We show that the phagemid is spread a thousand fold more than the helper plasmid. There are as many cells infected with the helper as cells infected by both helper and phagemid, that is to say, phages producing cells. THose results show the validity of using this system to spread a genetic element in a bacterial population. Most of the cells bear the desired genetic element and the spread is carried on by a minor quantity of cells producing the vector.

Figure 4. Characterization of the phagemid helper system

The critical role of using a low cost element

  

Figure 5. Characterization of the phagemid helper system

Making a Chloramphenicol resistant E. Coli population sensitive to Chloramphenicol

   We used the a phagemid bearing the sRNA anti-Cm we designed to infect a population of chloramphenicol resistant cells. By applying the sequential killing strategy described in Figure 3, we efficiently killed 99,1% of the bacterial population (chloramphenicol concentration 500ug/ul). We tested this strategy with different concentrations of chloramphenicol. We show that the rise of chloramphenicol concentration directly lead to drastic reduction of the survival of the infected cells.

   In order to show the general application of our system, we then applied the same strategy on MG1665 transformed with pCOLA Duet. Those kanamycine resistant cells were infected with phages bearing our sRNA anti Kan. 99,87% of the population was killed (standard deviation 0,23 %) at 500mg/mL of kanamycine.

Figure 6. Killing Chloramphenicol resistant E. Coli population with Chloramphenicol

Charaterization of the origin of resistance

   One of the main limit of our system could be the development of resistances. Indeed, because our system uses two tools, there are at least two ways to become resistant : by avoiding infection or developing a resistance to the silencing. In order to get a better idea of what will be the main way to achieve resistance we screened the survivor colonies for GFP expression. GFP positive colonies correspond to infected cells with malfunctioning silencing. We show that 70% of resistance is caused by a resistance towards the sRNA. This problem could be partially due to a mismatch between the sRNA sequence and the target sequence. Therefore, our strategy could be improved by using diffeent phages bearing the main versions of the same resistance gene.

Figure 7. Origin of resistance to the sequential killing

Conclusion and perspectives

   Several sRNA on the same plasmid : BLABLABLA

   Building a library of sRNA : BLABLABLA

   Possible Applications : BLABLABLA

Litterature

Na D, Yoo SM, Chung H, Park H, Park JH, Lee SY. Metabolic engineering of Escherichia coli using synthetic small regulatory RNAs. Nature Biotechnology(2013).

Monica E Ortiz and Drew Endy. Engineered cell-cell communication via DNA messaging. Journal of Biological Engineering (2012).

Seung Min Yoo, Dokyun Na and Sang Yup Lee. Design and use of synthetic regulatory small RNAs to control gene expression in Escherichia coli. Nature Protocols 8, 1694–1707 (2013).

Woodford N, Wareham DW; UK Antibacterial Antisense Study Group. Tackling antibiotic resistance: a dose of common antisense? The Journal of Antimicrobial Chemotherapy. 2009 Feb;63(2):225-9.

Centre for Research and Interdisciplinarity (CRI)
Faculty of Medicine Cochin Port-Royal, South wing, 2nd floor
Paris Descartes University
24, rue du Faubourg Saint Jacques
75014 Paris, France
+33 1 44 41 25 22/25
team2013@igem-paris.org
Hit Counter by Digits
Copyright (c) 2013 igem.org. All rights reserved.