"
02/09/13
From 2013.igem.org
(Difference between revisions)
| Line 13: | Line 13: | ||
</div> | </div> | ||
==Preparation of IPTG and Chloramphenicol plates== | ==Preparation of IPTG and Chloramphenicol plates== | ||
| - | *The IPTG/Chloramphenicol plates that were prepared earlier on | + | *The IPTG/Chloramphenicol plates that were prepared earlier on [[08/08/13]] for the volatile organic compound (VOC) test were found to be contaminated. |
* Hence new plates had to be made using the below protocol; | * Hence new plates had to be made using the below protocol; | ||
Revision as of 12:02, 2 September 2013
| Home | Team | Official Team Profile | Project | Parts Submitted to the Registry | Modeling | Notebook | Safety | Attributions |
|---|
Preparation of IPTG and Chloramphenicol plates
- The IPTG/Chloramphenicol plates that were prepared earlier on 08/08/13 for the volatile organic compound (VOC) test were found to be contaminated.
- Hence new plates had to be made using the below protocol;
PROTOCOL:
- x2 400ml of already prepared and sterilized agar was obtained from the media kitchen.
- The agar was microwaved using the lowest power level at 2-3 mins intervals until completely melted.
- The x2 400ml agar were then placed in the 37 degrees room to cool.
- After cooling, 800ul of cholramphenicol and 400ul of IPTG were added to one bottle whilst only 800ul of chloramphenicol was added to the second bottle.
- The contents of both agar bottles was then poured into ...
