Team:BYU Provo/Results/Experimental

From 2013.igem.org

(Difference between revisions)
(Isolation of Phage Library)
Line 40: Line 40:
===Isolation of Phage Library===
===Isolation of Phage Library===
-
[[File:Changethecapsidsize.png|600px|center|link=https://static.igem.org/mediawiki/2013/3/36/Changethecapsidsize.png]]
+
[[File:Changethecapsidsize.png|500px|center|link=https://static.igem.org/mediawiki/2013/3/36/Changethecapsidsize.png]]
<br>
<br>

Revision as of 02:57, 28 September 2013


Experimental Results


Results Overview
Judging Criteria
* Bronze
* Silver
* Gold
Experimental Results
Modeling Results
Parts Submitted

Phage Team

Isolation of Phage Library

Changethecapsidsize.png


Results of Mutant T4 Phage Isolation

T4capsidvariation.png


T4CsClTube.png


Results of Mutant T7 Phage Isolation

T7protocol.png

As part of creating our bacteriophage library, we wanted to isolate both smaller and larger T7 bacteriophages. To do so, we first mutagenized T7 by growing it in the presence of 5-bromodeoxyuridine, a mutagenic base analog. This produced many mutant T7 bacteriophages, but they were hard to find amongst all the wild type T7. Therefore the phage purification team ran the mutagenized bacteriophage through a cesium chloride gradient. This separated the phage according to size, with the biggest phage traveling farther down. After determining where the mutant phage is in the gradient, we then plated the phage and looked for plaques that were smaller or larger than normal. Out of the 31 plaques we selected, two of them reproduced their plaque sizes, revealing that they were indeed mutant T7 bacteriophage! This can be seen in the two pictures below. The S4 plate with small phage produced larger plaques, while the L8 plate with large phage produced smaller plaques. The next step will be to get pictures of the phage with an electron microscope and sequence the genome to determine where the mutations occurred.

SmallResults.png
LargeResults.png



Cholera Team

Cholera Induces Bacteriophage Lambda From Lysogeny to its Lytic Cycle

Byuk.jpg


Designing SdiA to be Specific for Cholera

BYUK Apr10-4.JPG

In the beginning our plan was to transform into E.coli the most essential parts of the V.cholerae quorum sensing system. This was done, but our response proteins GFP and RFP did not work as expected.Shown above are colonies that were not supposed to be glowing. So we decided to try mutating the quorum sensing system E.coli already had to be able to only sense CAI-1 which is an auto-inducer specific to V.cholerae.

BYU slide 4 again.jpg

Below is a T coffee alignment of SdiA (E.coli protein involved in quorum sensing response) and CqsS (receptor protein in V.cholerae that can only sence CAI-1). It was found that the amino acids corresponding to the binding pocket for auto-inducers of both proteins lined up in the alignment indicating a similar structure. We hypothesized that if the five amino acids in SdiA that are known to be important in auto-inducer molecule binding were changed we could make SdiA a more specific receptor instead of a promiscuous one. According to our alignment two of the five amino acids were already the same between SdiA and CqsS (black arrows). The other three amino acids we decided to change in SdiA through site directed mutagenesis to be the same as CqsS(Blue arrows).

BYU CqsS SdiA binding pocket.png
BYU planned experiment SdiAmutant.jpg


Biofilm inhibition by Amylase

The enzymatic activity of α-Amylase was characterized to determine its capacity to inhibit biofilm formation by V. cholerae. Samples were prepared by adding 50 µL of V. cholerae culture to 1 mL of a high salt LB. The samples were then treated by the addition of purified α-Amylase in various concentrations and allowed to incubate at 30°C for 48 hours. After 48 hours the samples were examined and a distinct difference was seen in the amount of biofilm formed in the treated and untreated samples.

BYU2013-BiofilmAssay1.jpg BYU2013-BiofilmAssay2.JPG


The samples were then transferred to eppendorf tubes and centrifuged at 16,000 × g for two minutes, the supernatant was discarded to remove the growth media, and the samples were resuspended in 200 µL ddH2O. The samples were then stained with 50 µL of a 0.03% CV solution and allowed to incubate for five minutes. The samples were again centrifuged at 16,000 × g for two minutes and the supernatant containing excess CV was discarded. The pelleted biofilm was then washed with 800 µL of 95% EtOH without resuspension, centrifuged for 30 seconds, and the EtOH was discarded. The EtOH wash was repeated twice more for a total of three washes. The samples were then resuspended in 200 µL EtOH, transferred to a 96-well plate, and incubated for five minutes. The plate was then shaken for ten seconds and absorbance readings were taken for each sample at 540 nm, the absorbance wavelength of CV.


BYU2013-BiofilmAssayGraph1.jpg

The above graph shows both the average pellet weight and the average absorbance readings for samples treated with 0, 2.5, 12.5, and 25 µL of α-Amylase. There is a distinct reduction in the amount of biofilm growth between untreated and treated samples, with samples treated with 25 µL α-Amylase showing a 65.8% decrease in biofilm formation after 48 hours. While this clearly shows the ability of α-Amylase to inhibit biofilm formation by V. cholerae, further characterization is needed to determine the capacity of α-Amylase to degrade preexisting biofilms.