Team:Hong Kong HKUST/Project/module1

Cell Line

For our project we made use of two mammalian cell lines: HepG2 human hepatoma cells, and HEK293FT human embryonic kidney cells. HepG2 cells was used for characterizing inducible promoters and the glyoxylate systems. To take advantage of their higher transfection efficiency, the characterizations of mitochondria leader sequence and constitutive promoter were conducted using HEK293FT cells.

Cell Culture

HepG2 and HEK293FT cells were grown in DMEM supplemented with 10% heat-inactivated FBS, 50ug/mL penicillin and 50ug/mL streptomycin. The cells were incubated at 37℃ in a humidified atmosphere containing 5% CO2. Cells were transfected in petri dishes and multi-well plates with Lipofectamine 2000 (Invitrogen; Carlsbard, CA) transfection reagent according to the manufacturer’s protocols. GFP signals were observed under fluorescent microscope or under confocal microscope if necessary.

Cell Viability

We worked to introduce an inducible system that allows tunable fatty acid uptake regulated by fatty acid concentrations. Fatty acid uptake was to be quantified to compare the activity of wild type cells with the activity of our engineered cells expressing inducible glyoxylate shunt.

High fatty acid levels are known to lead to apoptosis, so we conducted cell viability tests using MTT assay at different sodium palmitate concentrations.

The objective was to determine the range of fatty acid concentrations to be introduced into our cells that would allow more than 60% viability after 24 hours incubation and/or more than 50% in 48 hours.

MTT assay description

CMTT assay measures the enzymatic activity of oxidoreductase enzymes that only show activity when the cells are alive. MTT, a tetrazolum dye, is reduced into an insoluble formazan, giving a purple color. Organic solvent such as DMSO can be used to dissolve the formazan. Absorbance at 570 is measured using a spectrophotometer to quantitatively determine the amount of formazan formation.

In our experiment, HepG2 cells were seeded into a 96-well plate. After one day incubation gradient concentration of sodium palmitate from 0 mM to 1.0mM, and 2.0mM were added into each row. After adding the sodium palmitate, we have incubated the cells for 24 hours and 48 hours respectively. MTT reagent was added and formazan formation was observed and measured using spectrophotometer.

Results

From the MTT assay, we observed that after 24 hours of incubation with palmitic acid, around 45% of cell viability can be maintained even at 2.0mM. For 48 hours incubation, cell viability varied for different concentrations. To maintain 50% cell viability after 48 hours incubation with palmitic acid, we concluded to experiment within range from 0mM to 0.32 mM of palmitic acid. Click on the pictures beside for a detailed result on cell viability.

Fatty Acid Quantification

Two fatty acid quantification methods were investigated to measure fatty acid uptake rate of constitutive and inducible glyoxylate system: 1) Gas Chromatography-Mass Spectrophotometry (GC-MS), and 2) Fatty acid quantification kit (Sigma Aldrich). While we managed to measure fatty acid amount in cell culture medium using GC-MS, fatty acid quantification kit could not be tested due to limitation of time.

Fatty Acid Treatment

In measuring fatty acid, fatty acid solution was mixed with ethanol and chloroform. After acidifying by HCl and refluxing in water bath for 30 min, the organic layer containing fatty acid was collected and extracted by diethyl ether and petroleum ether solution. Again the organic layer was sucked out to be dried before NaOH was added. Then after derivatisation by BF3 and bromotetradecane, the organic layer was collected into GC-MS vial for analysis.

GC-MS

GC-MS is a very useful tool to quantify volatile compounds effectively. For our experiment, we conducted calibration test using known concentrations of fatty acids. However, it was difficult to reach a conclusion due to lack of internal standards and uncertain amount of sample loss for