Enter of Bee. coli

Introduction

In this part, the main purpose is to send Bee. coli into bees and make sure it can survive in the midguts. Therefore, we chose Escherichia coli MG1655 as the chassis of our circuit, then incorporating MG1655 into alginate microcapsules, and fed bees with sugar water containing microencapsulation beads. According to our experiment, it could successfully transport the engineered Bee. coli into the bees’ midgut.

Background

Why encapsulation?

The host immune system imposes a great threat on our engineered “E.coli”. Besides we have to transported our engineered “E.coli” in the bees through bees’ digest system, which may contain many kinds of digestive solution with variable pH value that do harm to our engineered “E.coli”.

To solve this problem, we have to cover the “E.coli” with a membrane. And encapsulation is an easy way to reach the goal. Comparing to other approaches, cell encapsulation is easy to manipulate. So we choose cell encapsulation as the approach to cover the “E.coli”.

Materials

File:NYMU TAIPEI alginateacid.png There are many different biomaterials for cell encapsulation. Among those biomaterials, we chose alginate as our encapsulation material for its abundance, excellent biocompatibility and biodegradability properties.

Results of encapsulation

We successfully encapsulated the engineered “E.coli”( “E.coli” with GFP gene), and controlled its size between 10 to 200nm. Then we tried to transfer the engineered “E.coli” into bees midgut by adding some beads into their food. The experiment result indicate that the engineered “E.coli” have made into the bees’ midgut successfully.

Products—Be”E.coli”

The sugar cube with engineered “E.coli” in it.

After we proved that microencapsulation of “E.coli” could be sent into midgut through bees’ digestion system, we came up with an idea that we can create a drug-like product which is the mixture of sugar and microencapsulation of engineered “E.coli”. So we mixed the solution of microencapsulation with sugar cube and dry it. Then, we create the drug powder which can cure CCD.

Experiments

Comparison of DH5 alpha and MG1655

We transformed red fluorescent protein into MG1655 and DH5 alpha, and then spread these bacteria onto the LB agar plates. After cultured at 37 degree for 16 hours, we calculated the number of colonies and found the transformation efficiency of DH5 alpha is about 100-fold higher than MG1655.

DH5 alpha	MG1655

Oxidative stress tolerance of MG1655

To know the oxidative stress tolerance of MG1655, we tested the susceptibility to H₂O₂ in MG1655.

Survival test

1. MG1655 cells were cultivated at 37 ˚C until the optical density (OD600) of the medium became 0.4~0.6
2. The culture was equally dispensed (1 ml each) into sample tubes, and then cells were treated with various concentrations of H₂O₂ (final concentrations were as follows: 10μM, 50μM, 100μM, 500μM, 1 mM, 5mM, 10mM, 50mM and 100mM) at 37 ˚C for 60 min
3. Testing the OD of each samples
4. Doing serial dilution on samples by mixing fresh LB medium with samples
5. 20μl of the diluted sample was spread out on a LB plate (amp-) and incubated at 37 ˚C (overnight)
   

Results and discussion

Susceptibility to H2O2 in MG1655 shown in OD	Susceptibility to H2O2 in MG1655 shown in colonies

From these charts, the oxidative stress tolerance of MG1655 is higher than 5mM, and epithelial cells is only 0.05mM. In the other words, the tolerance to ROS of MG1655 is over 100-fold higher than cells in midgut. Therefore, MG1655 will survive even in the stress environment in the midgut.

Treated with 100mM H2O2 diluted 104times	Treated with 50mM H2O2 diluted 104times	Treated with 10mM H2O2 diluted 105times	Treated with 5mM H2O2 diluted 105times	Treated with 1mM H2O2 diluted 106times
Treated with 500μM H2O2 diluted 106times	Treated with 100μM H2O2 diluted 107times	Treated with 50μM H2O2 diluted 107times	Treated with 10μM H2O2 diluted 107times	Treated with 0μM H2O2 diluted 107times

Comparison table of MG1655 and DH5 alpha

Entering the bees' midgut

Getting into bees’ midgut

left up: bees' gut , right up: no fluorescent light, left down: bees' gut after fed “E.coli”, right down: lots of fluorescent signal

We dropped some solution with microencapsulation of “E.coli” on the sugar cube. After three days, we pulled out bees’ midgut and see if there was engineered “E.coli”. We also pulled out bees’ midgut from those who did not intake engineered “E.coli” and compared the result.

Products

left up: bees' gut , right up: no fluorescent light, left down: bees' gut after fed our product, right down: lots of fluorescent signal

After the engineered “E.coli” was made into our powder product, we wondered that if the engineered “E.coli” still work. We dissolved our powder product in sugar water and fed our bees. After 3 days, we pulled out bees’ midgut and see if there was any engineered “E.coli”. The result show that there were still engineered “E.coli”, that was our product really work.

Outcome

We selected MG1655 as the chassis of our circuit, then successfully finding a way which can avoid the threat of immune system and ensure that Bee. coli won't spread into the environment to transport Bee. coli into bees. Besides, once our chassis entered the midguts of bees, it is able to survive and fight against Nosema. We mixed the solution of microencapsulation beads with sugar powder and dried it. That's what we called CCD-curing powder.