Cell Culture and Transfection

We cultured HEK 293FT cells following ATCC’s standard procedure, except that we have used DMEM with 10% FBS and 1% penicillin/streptomycin for culture medium. For transfection, we have followed the manufacturer’s protocol of LipofectamineTM 2000 (Invitrogen). We have used serum free and antibiotics free DMEM to form DNA-lipofectamine complex.

Cell Line

In our project, two mammalian cell lines were used: human hepatoma cell (HepG2 cell) and human embryonic kidney 293 cell (HEK293FT). HepG2 cell was used for characterizing inducible promoters and glyoxylate systems. For higher transfection efficiency, the characterizations of mitochondria leader sequence and constitutive promoter were conducted using HEK293FT cells.

Cell Culture

HepG2 and HEK293FT cells were maintained in DMEM supplemented with 10% heat-inactivated FBS and 50ug/mL penicillin, 50ug/mL streptomycin at 37℃in a humidified atmosphere containing 5% CO2. Cells were transfected in petri dishes and multi-well plates with different construct Lipofectamine 2000 (Invitrogen; Carlsbard, CA) according to manufacturer’s protocols. Any GFP signals were observed under fluorescent microscope or under confocal microscope if necessary.

Cell Viability

We designed to introduce an inducible system that allows tunable fatty acid uptake by sensing fatty acid concentrations. Fatty acids uptake was to be quantified to compare the activities of wild type cells and cells expressing inducible glyoxylate shunt.

To facilitate expression of inducible glyoxylate shunt in human hepatoma cell line (HepG2 cell), cell viability at different sodium palmitate concentration was measured. While a high fatty acid level is known to lead apoptosis, the cell viability test ensured maintenance of a stable cell line for transfection.

We used MTT assay to test cell viabilities in different fatty acid concentrations. The objective was to determine a range of optimal concentrations of fatty acids to be introduced into HepG2 cell and achieve more than 60% viability after 24 hours incubation and/or more than 50% in 48 hours.

MTT Assay Description

MTT assay measures the enzymatic activity of oxidoreductase enzymes that only show activity when the cells are alive. MTT, a tetrazolum dye, is reduced into an insoluble formazan, giving a purple color. Organic solvent such as DMSO can be used to dissolve the formazan. Absorbance at 570 is measured using a spectrophotometer to quantitatively determine the amount of formazan formation.

In our experiment, HepG2 cells were seeded into a 96-well plate. After one day incubation gradient concentration of sodium palmitate from 0 mM to 1.0mM, and 2.0mM were added into each row. After adding the sodium palmitate, we have incubated the cells for 24 hours and 48 hours respectively. MTT reagent was added and formazan formation was observed and measured using spectrophotometer.

Fatty Acid Treatment

In measuring fatty acid, fatty acid solution was mixed with ethanol and chloroform. After acidifying by HCl and refluxing in water bath for 30 min, the organic layer containing fatty acid was collected and extracted by diethyl ether and petroleum ether solution. Again the organic layer was sucked out to be dried before NaOH was added. Then after derivatisation by BF3 and bromotetradecane, the organic layer was collected into GC-MS vial for analysis.

GC-MS

GC-MS is a very useful tool to quantify volatile compounds effectively. For our experiment, we conducted calibration test using known concentrations of fatty acids. However, it was difficult to reach a conclusion due to lack of internal standards and uncertain amount of sample loss.