Team:UANL Mty-Mexico/Project/Overview

RNA thermometers (RNATs) are RNA sequences that range from 40 to more than a 100 nucleotides commonly found in the 5' untranslated region of some genes and that regulate in cis their translation without the need of other factors [Kortmann and Narberhaus, (2012); Narberhaus, (2009)]. These RNAT sequences show certain three dimensional structures, some of which interact with the ribosome binding site (RBS) of their regulated genes and hinders the proccessivity of the ribosome complex at certain temperatures. The dynamics of the formation of these structures is temperature dependent and is the basis of the regulation of the translation rate of a given transcript [Chowdhury, S., et al.,(2006); Narberhaus, F., et al.,(2006)].

Functional RNAT have been found in different organisms, mainly pathogenic bacteria, and many others have been predicted in almost everyfrom a number of bioinformatic studies. They have been found to regulate the expression of virulence factors, heat and cold shock response factors and even proteins involved the development of some bacteriophages.

Their apparent widespread presence in living organisms has made RNATs attractive for some applications, specially the ones related to the replacement of chemical inducers and for the development of new drugs.

However, from the experience of those who have been working extensively with RNAT in the later years, the accurate bioinformatic prediction of functional RNAT has proven to be an exceptionally difficult task; the reasons for this are pointed to be the poor sequence conservation observed among RNATs and the gaps in our current understanding of the RNAT function, their structural diversity and the effect of other regulatory sequences far from the RBS region [Kortmann and Narberhaus, (2012); Waldminghaus, et al., (2007)].

Types of natural RNA thermometers  Back to top

Our genetic circuit combines two synthetic RNATs and three transcription factors, through which we intend to gain temperature-mediated control over the transition of three discrete states, signaled by the expression of distinct fluorescent proteins. The figure below shows the topology of the proposed circuit. 

At temperatures below 32ºC, called state 0, no reporter protein is produced. Above 32ºC, the first RNAT is melted thus allowing the translation of GFP transcripts (figure 1a) and the system enters state 1. Note that, despite the fact that GFP transcription is under the regulation of a Lac promoter, LacI is not being produced so far as its translation is prevented by a different RNAT. 

When the system reaches 37ºC, mCherry’s RNAT melts allowing it to be translated (figure 1b) and the system enters state 2. At this point, LacI repressor -whose translation is regulated by the same RNAT- is produced, therefore repressing GFP. Again, note that even if mCherry is transcribed from a Tet promoter, Tet repressor’s transcription is blocked by cI represor. 

Finally, if the system reaches a temperature above 42ºC, the system is shut down (figure 1c). This is achieved because the cI repressor herein used is thermolabile, and above 42ºC it is no longer able to bind its operator and repress transcription. Hence, both LacI and Tet repressors are again produced blocking the transcription of GFP and mCherry, respectively.  

1. Kortmann J, Narberhaus F (2012) Bacterial RNA thermometers: molecular zippers and switches. Nat Rev Micro, 10:255-265
2. Saheli Chowdhury, Christophe M, Allain F, Franz Narberhaus F (2006) Molecular basis for temperature sensing by an RNA thermometer. The EMBO Journal, 25:2487-2497
3. Neupert J, Karcher D, Bock R (2008) Design of simple synthetic RNA thermometers for temperature- controlled gene expression in Escherichia coli. Nucleic Acids Res, 36:e124.
4. BYU Provo iGEM 2008 https://2011.igem.org/Team:BYU_Provo