Team:ZJU-China/Project/GhostSensor/Results

From 2013.igem.org

(Difference between revisions)
(→Detect thrombin using membrane scaffold FA and FB)
m (→Subcellular distribution of inner-membrane scaffolds)
 
(32 intermediate revisions not shown)
Line 12: Line 12:
__TOC__
__TOC__
== '''Characterize the function of protein E''' ==
== '''Characterize the function of protein E''' ==
-
'''1.1''' Protein E was put under the control of pBAD promoter. We recorded the growth curve of transformed E.coli cells treated with different concentrations of L-arabinose varying from 0.2% to 1%. MgSO4 has been reported to allow the expression of protein E but inhibit lysis. MgSO4 was added 30min before the induction according to previous works by others. The results showed that even as low as 0.2% L-arabinose can efficiently induce the lysis E.coli.
+
'''1.1''' Protein E was put under the control of pBAD promoter. We recorded the growth curve of transformed E.coli cells treated with different concentrations of L-arabinose varying from 0.2% to 1%. MgSO<sub>4</sub> has been reported to allow the expression of protein E but inhibit lysis. MgSO<sub>4</sub> was added 30min before the induction according to previous works by others. The results showed that even as low as 0.2% L-arabinose can efficiently induce the lysis E.coli.
<center>[[File:Pe.JPG|500px]]</center>
<center>[[File:Pe.JPG|500px]]</center>
-
'''1.2''' The lysed products were viewed under SEM and TEM to confirm the formation of tunnels. MgSO4 allows production of protein E, but inhibits lysis. 150min later cells were collected by centrifugation and resuspended in water causing immediate lysis by osmotic shock. This procedure would produce holes approximately equal in size to the diameter of the cell.
+
'''1.2''' The lysed products were viewed under SEM and TEM to confirm the formation of tunnels. MgSO<sub>4</sub> allows production of protein E, but inhibits lysis. 150min later cells were collected by centrifugation and resuspended in water causing immediate lysis by osmotic shock. This procedure would produce holes approximately equal in size to the diameter of the cell.
[[File:ZJU-ghostsensor-result-2.png|330px|left]]
[[File:ZJU-ghostsensor-result-2.png|330px|left]]
Line 24: Line 24:
<small>
<small>
-
Left: SEM picture of protein E lysed E.coli.  
+
<center>
 +
Left: SEM picture of protein E lysed ''E.coli''.  
-
Right: SEM picture of protein E lysed E.coli with MgSO<sub>4</sub> protocol. The tunnel is relatively bigger than the left one.
+
Right: SEM picture of protein E lysed ''E.coli'' with MgSO<sub>4</sub> protocol. The tunnel is relatively bigger than the left one.
 +
</center>
</small>
</small>
<center>
<center>
-
[[File:ZJU-ghostsensor-result-4.png|300px]]
+
[[File:3-1-50000X--3.png|300px]]
-
TEM showing protein E lysed E.coli
+
Protein E mediated lysis of ''E.coli'' under TEM. A presumable efflux of cytoplasmic material is indicated by the arrow.
</center>
</center>
 +
'''1.3''' Determine the lysis ratio of protein E. The bacterial culture was diluted in a ratio 1:10,000 before and after the induction by L-arabinose. Then 100μL was taken to a non-antibotic plate and culture at 37C for 5hrs. The lysis ratio was determined by the equation: lysis ratio=(1-cfu before induction/cfu after induction)*100%.
 +
 +
<center>
 +
[[File:ZJU-Bacterial-Ghost-Results-5.jpg|620px]]
 +
</center>
 +
<center>
 +
<small>
 +
The cells in left plate were induced while the right plate was not. <br>
 +
(The lysis ratio=(1-102/9690)*100%=98.9%)
 +
</small>
 +
</center>
 
 
Line 76: Line 89:
SsDsbA is the signal recognition particle (SRP)-dependent signaling sequence of DsbA. ssDsbA-tagged proteins are thus destined to export to the periplasmic space via the SRP pathway. With ssDsbA fused to the N-terminus, fusion inner-membrane proteins with transmembtrane domain are expected to be anchored onto inner membrane of ''E.coli''.  
SsDsbA is the signal recognition particle (SRP)-dependent signaling sequence of DsbA. ssDsbA-tagged proteins are thus destined to export to the periplasmic space via the SRP pathway. With ssDsbA fused to the N-terminus, fusion inner-membrane proteins with transmembtrane domain are expected to be anchored onto inner membrane of ''E.coli''.  
-
[[File:ZJU-GhostSensor-4.png|330px|left]]
+
[[File:ZJU-GhostSensor-4.png|330px]]
-
[[File:ZJU-GhostSensor-5.png|330px|right]]
+
[[File:ZJU-GhostSensor-5.png|300px]]
<html><div class="clean"></div></html>
<html><div class="clean"></div></html>
Line 83: Line 96:
We believe the nature to be rational and inferable. Logistically, because the construction of bacterial ghost is successful and cytosol would flow out to be replaced by PBS buffer, the fluorescence should come from nowhere but the membrane. In such way, we assume that our protein scaffolds have been successfully anchored to the inner-membrane of ''E. coli''.
We believe the nature to be rational and inferable. Logistically, because the construction of bacterial ghost is successful and cytosol would flow out to be replaced by PBS buffer, the fluorescence should come from nowhere but the membrane. In such way, we assume that our protein scaffolds have been successfully anchored to the inner-membrane of ''E. coli''.
-
 
-
== '''Detect thrombin using membrane scaffold FA and FB''' ==
 
-
We expressed the first set of membrane scaffolds with split EGFP fragments FA and FB fused to the periplasmic end. Then we tested the function of our membrane scaffolds by adding two sets of aptamers with different linker length. The concentration of thrombin in the solution was adjusted to 0.2nM. 29-mer aptamer and 15-mer aptamer efficiently induced dimerization of membrane scaffolds (Figure C, D versus A) and led to green fluorescence emission under confocal microscopy. 
 
-
 
-
[[File:ZJU-ghostsensor-result-A.png|330px|left]]
 
-
[[File:ZJU-ghostsensor-result-B.png|330px|right]]
 
-
 
-
[[File:ZJU-ghostsensor-result-C.png|330px|left]]
 
-
[[File:ZJU-ghostsensor-result-D.png|330px|right]]
 
-
<html><div class="clean"></div></html>
 
-
 
-
<center>
 
-
<small>
 
-
 
-
(Fluorescence with or without aptamers. BL21 competent cells were co-transformed with FA, FB and protein E. When the OD-600 value reached 0.4, 0.4% was added to induce the expression of protein E. 2h later cells were harvested and washed two times with PBS. 5µL of bacteria were resuspended in 200 µL PBS, and a final concentration of 0.2nM thrombin was added to the solution. Different aptamers were also included in this point. The reaction system was incubated with shaking in room temperature for 30 min and then green fluorescence was viewed under confocal microscopy. Only very weak green fluorescence was visible when no aptamers were added to the reaction system (A). Biotinylated thrombin can readily induce membrane scaffolds dimerization because there were typically 1-4 biontin in one molecule leading to scaffolds crosslinking (B). 15-mer and 29-mer aptamer with short (C) or long (D) linkers were both effective in inducing crosslinking. But it seemed that long linkers (D) is more potent than short linker (C) in this system. )
 
-
 
-
</small>
 
-
</center>
 
-
 
-
<center>
 
-
 
-
<small>
 
-
(The upper figure demonstrates another two typical confocal image of '''E.coli''' with (C) or without (A) aptamers. Figure B and D shows the fluorescent intensity distribution across the image on the left accordingly.) 
 
-
 
-
</small>
 
-
<center>
 
Line 117: Line 104:
</div>
</div>
<div style="float:right;">Next:  
<div style="float:right;">Next:  
-
   <a href="./Perspectives">Bacterial Ghost: Perspectives</a>
+
   <a href="../TheGhostKit/GhostSensor">The Ghost Kit: Ghost Sensor</a>
</div>
</div>

Latest revision as of 03:28, 29 October 2013

Flag Counter

Bacterial Ghost: Results

Contents

Characterize the function of protein E

1.1 Protein E was put under the control of pBAD promoter. We recorded the growth curve of transformed E.coli cells treated with different concentrations of L-arabinose varying from 0.2% to 1%. MgSO4 has been reported to allow the expression of protein E but inhibit lysis. MgSO4 was added 30min before the induction according to previous works by others. The results showed that even as low as 0.2% L-arabinose can efficiently induce the lysis E.coli.

Pe.JPG

1.2 The lysed products were viewed under SEM and TEM to confirm the formation of tunnels. MgSO4 allows production of protein E, but inhibits lysis. 150min later cells were collected by centrifugation and resuspended in water causing immediate lysis by osmotic shock. This procedure would produce holes approximately equal in size to the diameter of the cell.

ZJU-ghostsensor-result-2.png
Bacterioghostsem2.jpg

Left: SEM picture of protein E lysed E.coli.

Right: SEM picture of protein E lysed E.coli with MgSO4 protocol. The tunnel is relatively bigger than the left one.

3-1-50000X--3.png

Protein E mediated lysis of E.coli under TEM. A presumable efflux of cytoplasmic material is indicated by the arrow.

1.3 Determine the lysis ratio of protein E. The bacterial culture was diluted in a ratio 1:10,000 before and after the induction by L-arabinose. Then 100μL was taken to a non-antibotic plate and culture at 37C for 5hrs. The lysis ratio was determined by the equation: lysis ratio=(1-cfu before induction/cfu after induction)*100%.

ZJU-Bacterial-Ghost-Results-5.jpg

The cells in left plate were induced while the right plate was not.
(The lysis ratio=(1-102/9690)*100%=98.9%)

 

Characterize the function of aptamers

We chose two well-characterized aptamers, namely 15-mer and 29-mer aptamers, targeting two different sites of thrombin. In order to achieve optimal spatial distance, we linked each of them with either short or long linkers (the underlined sequence below indicates the linker sequence).

Thrombin aptamers with Short linker:

5’-biotin-ttttttggttggtgtggttgg

5’-biotin-tttagtccgtggtagggcaggttggggtgact


Thrombin aptamers with Long linker:

5’-biotin-ttttttttttttggttggtgtggttgg

5’-biotin-tttttttttagtccgtggtagggcaggttggggtgact


As our aptamers were biotin modified, we used a streptavidin beads pull down assay to see if these aptamers were capable of binding to thrombin.


ZJUaptamerpulldown.jpg

(Coomassie blue staining of thrombin digested products. 20μL of streptavidin beads and final concentration of 50nM thrombin were added to a 300μL PBS solution. A final concentration of 50nM 15-mer aptamer with short linker (lane2), 29-mer aptamer with short linker (lane 3), 15-mer aptamer with long linker (lane4) and 29-mer aptamer with long linker (lane 5) were added respectively. No aptamers were added to lane 1. Beads were washed and resuspended and moved to a new solution of purified proteins in which a thrombin cutting site is included to allow digestion.)

Subcellular distribution of inner-membrane scaffolds

SsDsbA is the signal recognition particle (SRP)-dependent signaling sequence of DsbA. ssDsbA-tagged proteins are thus destined to export to the periplasmic space via the SRP pathway. With ssDsbA fused to the N-terminus, fusion inner-membrane proteins with transmembtrane domain are expected to be anchored onto inner membrane of E.coli.

ZJU-GhostSensor-4.png ZJU-GhostSensor-5.png

We tried to confirm the localization of our inner-membrane scaffolds by looking at the subcellular distribution of green fluorescence in the cell. However, our confocal microscopy doesn't possess enough resolution to let us distinguish the subcellular localization of the fluorescence. So we resort to another way to tackle this problem.

We believe the nature to be rational and inferable. Logistically, because the construction of bacterial ghost is successful and cytosol would flow out to be replaced by PBS buffer, the fluorescence should come from nowhere but the membrane. In such way, we assume that our protein scaffolds have been successfully anchored to the inner-membrane of E. coli.


Sponsors
The logo of Zhejiang University

Retrieved from "http://2013.igem.org/Team:ZJU-China/Project/GhostSensor/Results"