Team:Freiburg/Project/modeling

Introduction

Effectors

Effector Control

Targeting

uniBAss

Manual

Modeling

Introduction

The Networks

1. dCAS-VP16

Our network includes four different components dCas-VP16, a RNA complex (tracr/cr RNA), a RNA-dCas-VP16 complex and the Secreted alkaline phosphatase (SEAP). DCas-VP16 binds the RNA-complex and the whole complex binds the DNA, which leads to the production of SEAP.

Fig. 1: Transcriptional Activation via dCAS-VP16: The dCAS-VP16 fusion protein is guided to the desired DNA sequence by a co-expressed crRNA and tracrRNA. The binding of the gene recognition complex leads to an expression of SEAP.

Setting up the ODE

According to the graphical reaction network the ODE can be set up.

Cas9 is constitutively expressed by the CBh promoter and degraded proportional to the current concentration. It is used to build the DNA recognition complex and produced during complex decay.

The RNA-complex is build linearly. The production constant can be seen as production constant of the lower expressed RNA, because this expression limits the complex building. It is assumed that the RNA is degraded after DNA recognition complex decay and therefore the complex decay does not lead to more RNA.

The DNA recognition complex is built, when Cas9 and RNA meets and degraded proportional to the current DNA recognition complex concentration.

There is a leaky SEAP production and one that depends on the current concentration of the Cas9/RNA Complex. This dependency is assumed to follow the Monod-kinetic. Because of the long half time (T₂ > 500 h) of SEAP we can neglect the SEAP decay [2, 3].

Finding the parameters

By setting up the ODE a n-dimensional hypothesis space (n is the number of parameters) is generated and finding the right parameter combination means finding a point in the space which fits the data best.
To find these parameters we used the maximum likelihood approach. The maximum likelihood hypothesis is the hypothesis which has the highest probability to generate the measured data. It is shown [3], that using the maximum likelihood approach and assuming gaussion noise in the data (an assumption that holds in our case) leads to a least-square error minimization problem.

A minimization problem is an optimization problem. You search for parameters (p0) for which holds, that the value of the function (f) at the point of the parameters is smaller than all other values. (f(p0)<=f(p)). In three dimensions the function can be thought as a landscape and minimization is finding the deepest valley. Depending on the method you use different problems arise. The most common problem is finding only a local minimum and not the global one.

Fig. 3: Example of a minimization problem. Shown is a 3D landscape. Depending on the start position (the initial parameters), the found minimum is either a local or the global one.

To avoid this and to be sure to have found a global minimum we started our minimization procedure using different start values for our parameters. To sample these parameters we used the latin hypercube sampling on a logarithmic scale.

Fig. 4: Illustration of the latin hypercube sampling in a two dimensional parameter space. The number of initial parameter vectors is 5. Therefore the parameter space is divided in 25 subspaces. Shown is one possible parameter combination.

N is set as the number of different initial parameter settings and the parameter range is divided by N. For the initial parameter the values are chosen so that there is only one parameter in each row and column.

The resulting errors we plotted in an increasing order to be sure to have found a global minimum.

Data generation

Cas is quantified by using Western blot and we used SEAP as target protein that can be quantified by a SEAP assay. For more detailed information refer our modeling notebook.

Sources

The Code Files