Plasmid purification

Principle

The aim of the purification step is to recover the plasmid produced by the bacteria (cloning strain).
The different step are use to throw other bacterial components off (proteins, cell wall, etc).

Preparation

1. Cell culture
Cultivate cells in LB medium overnight.

2. Cell harvesting
Set saturated E.coli LM culture into 2 mL tubes. Centrifuge at 11 000 x g for 30 secondes. Discard as much as supernatant as possible.

3. Cell lysis
Add 250 μL Buffer A1 (resuspension buffer). Resuspend the cells with a vortex or a pipette.
Add 250 μL Buffer A2 (lysis buffer). Mix gently by inverting the tube 6 - 8 times. Incubate at room temperature until lysate appears clear.
Add 300 μL Buffer A3 (neutralisation buffer). Mix thoroughly by inverting the tube 6 - 8 times .

4. Lysate clarification
Centrifuge at 11 000 x g for 5 minutes . Repeat this step until supernatant is not clear.

5. DNA Binding
Place a NucleoSpin Plasmid Column in a Collection Tube of 2 mL et and set the supernatant from the last step. Centrifuge at 11 000 x g for 1 minute. Discard flow-through and place the column back into the collection tube.

6. Membrane washing
Add 600 μL Buffer A4 (wash buffer) previously supplemented with ethanol. Centrifuge ar 11 000 x g for 1 minute. Discard flow-through and place the column back into an empty collection tube.

7. Dry membrane
Centrifuge at 11 000 x g for 2 minutes and discard the collection tube.

8. DNA Elution
Place the column in a 1,5 mL and add 50 μL de Buffer AE (elution buffer). Incubate at room temperature and centrifuge at 11 000 x g for 1 minute.

Test

Before the storage of the tubes at -20°C, measure the concentration with nanodrop.

260/280 ratio indicate ...
260/230 ratio indicate ...
If the concentration is between 30 and 50 ng/μL,
If the concentration is below 30 ng/μL or if 260/280 ratio or 260/230 ratio is respectively..., make another purification.