Team:UANL Mty-Mexico/Results

From 2013.igem.org

Revision as of 05:59, 27 October 2013 by Quintero (Talk | contribs)

Carousel Template for Bootstrap


Results at a glance



Figure 1. Predicted secondary structures of synthetic RNATs used in this project, as calculated by Mfold. The orange rectangles highlight nucleotides belonging to the SD sequence. a) 37ºC responsive RNAT b)32ºC responsive RNAT.



Figure 1 shows the predicted secondary structures of the two synthetic RNATs implemented in our project (designed by Neupert et al. and iGEM TuDelft 2008, respectively). So far, we detected fluorescence only with the 37ºC responsive RNAT, which controls mCherry's translation.

More



Figure 2 shows the visual appearance of cultures grown at 37ºC containing Part:BBa_K1140006 (37ºC RNAT_mCherry construction) (figure 2a), a non-fluorescent control (figure 2b), and a standard constitutively expressing RFP (figure 2c)

More

.

Figure 2. Temperature dependence of mCherry translation by 37ºC RNA thermometer in E. coli at 37ºC. a)37ºC RNAT mCherry b)Non-fluorescent control c)Standard constitutively expressing RFP.



Figure 3. Average relative fluorescence values of cultures carrying our construction (37ºC RNAT mCherry) incubated at 31 and 37ºC.




The synthetic RNAT proved to regulate expression in response to temperature changes. Fluorescence of cultures carrying our construction increases almost 4x from 31 to 37ºC (figure 3).

More





Surprisingly, we obtained different behaviors in clones transformed with the same DNA (figure 4). We identified variations in plasmid copy number as the potential cause of phenotypic discrepancies among clones.

More


Figure 3. Behavior of different clones transformed with Part:BBa_K1140006 (M1, 2, 11 and 12). Relative fluorescence values at 25, 30, 37 and 42 ºC are shown. All measurements were performed at least in triplicate, the aritmethic mean is shown.



Figure 4. Gaussian Function fitting of the experimental data shown in figure 3.


Mathematically, we found that a simple gaussian function fits our data well, and it provides us a way to quantify the strength (amplitude), optimal value (horizontal shift), and definition or clearness (width) of our RNAT activity (figure 4). It also allows for comparisons between different RNAT, as well as being potentially predictive for non verified temperatures.

More



What is in the charts?

All our experiments were performed in E. coli K12. For each measure in a given temperature, the system was left until a point in which we were sure the O.D of the cell culture and the production of the protein were in equilibrium, steady, and uniform, before the cells population started to decrease (which we found was 17h). The charts in our wiki show the fluorescence of our constructions relative to a standard constitutively expressing RFP, with values that go from 0 to 1. We took as a standard for the RFUs the amount of fluorescence emitted by an E. coli K12 culture transformed with Part:BBa_E1010 (the amount of fluorescence emitted by our culture was calculated by dividing the fluorescence of the sample by the fluorescence of the standard). Fluorescence values of a non-fluorescent control (noise) were subtracted from each measurement before calculating the relative fluorescence.


Creative Commons License