Team:Colombia Uniandes/Parameters

(Difference between revisions)

Revision as of 20:05, 18 July 2013

‹ ›

The second step in the deterministic model is to find the parameters that define the system. There are 3 possible ways to do this:

Literature: Many of the genes that we use in iGEM have been characterised before, and the constants that model their behaviour have been found. Sometimes an exact value is not found, so we have to find at least the order of magnitude or a range where the parameter can be found
Experiments: This is the most reliable way of knowing the parameters. But in our case we need the to perform de deterministic model first in order to see if the system works as expected in the lab. So the experimental way can only work to check if the parameters were correctly found.
Screening: If the parameters we are looking of are not found in literature we proceed to perform a screening of parameters as described in Colombia 2012 Team Wiki

Below is shown how we found the parameters for both of the projects:

After performing the literature research for the parameters the following values were found:

The values for these parameter varied a lot depending on the glucocorticoid detected; as in the lab is planned to test the circuit with Dexamethasone all the parameters were done for this glucocorticoid.
The values in red are the parameters that could not be found. An estimated order of magnitude was assessed with all the literature read.
As the part of the chimera that is going to activate transcription is Gal4p the values for the activation of the gene are assumed to be the same as the pure protein

@@ Line 30: / Line 30: @@
 <li>  The values in red are the parameters that could not be found. An estimated order of magnitude was assessed with all the literature read. </li>
+<li> As the part of the chimera that is going to activate transcription is Gal4p the values for the activation of the gene are assumed to be the same as the pure protein </li>
 </ul>
 == Nickel removal  system ==