High Pass Filter

Figure 4. Comparison of the Wild Type and PluxR1 mutant sensitivity curves in liquid cultureFor more details see below

The detection of different OHHL levels depending on the number of mines needs to have filters in our detection system. We decided to create a high pass filter by doing site directed mutagenesis of the wild type R0062 PLuxR promoter. The sites for mutagenisis were choose from litterature.
We were able to isolate one promoter having a lower expression level and beeing less sensitive than the wild type promoter. The promoter is called PluxR1 or G1 according to his initial position in the deep well plate.

Native N-3-Oxo-Hexanoyl-l-Homoserine Lactone tests using the Tecan Infinite M200 PRO™ plate reader

Figure 1: Sensivity curve of the wild type promoter and G1 mutant. The OHHL concentration range is plotted against the standarized fluorescence (au).
For the wild type : EC₅₀=5.86, R₂= 0.87,n=1.7
Fore The G1 mutant : EC₅₀=1'341, R₂= 0.98,n=0.8

In order to select mutated pLuxR promoters we need to know about the sensivity of the wild type construct. The test range was inspired form the paper about [http://www.ncbi.nlm.nih.gov/pubmed/18760602 Evaluation of a focused library of N-Acryl L-Homoserine lactone reveals a new set of potent quorum sensing modulators].The paper shows sensivities of the pLuxR promoter to different sets of OHHL molecules in Vibrio fisheri. We need to adjust the ranges for our E.coli DH5alpha strain in a second run and finally get our sensivity curve over the linear range of [0 nM],[0.25 nM],[0.5 nM],[1 nM],[2 nM],[3 nM],[4 nM],[5 nM],[10 nM],[20 nM],[30 nM],[40 nM]and[50 nM].

The experimental set-up includes a 96-well plate filled with 180 uL LB media , 10uL of receiver cells and 10 uL of different OHHL concentrations, everything in triplicates. (+ blank and negative control). The experiment runs for 16 hours in order to monitor the evolution of fluorescence and later choose the steady state to create the sensivity curve. The raw data is analyzed with GraphPad Prism 6.0.
After determination of the test ranges using the wild type promoter we apply the same protocol to the pLuxR1 (G1) mutant in order to compare their sensivity curves. See Figure 1.

PluxR random mutagenesis PCR

The pLuxR R0062 wild type promoter was mutated using site directed mutagenesis on specific sites according to the paper [put paper here]

PluxR promoter with different sensitivity analyzed using the single cell analyzer BD LSRFortessa™ Flow Cytometer System

The fitting of the following graphs was perfomed using the previous equation.the equation consists of :
Output = sfGFP levels [au] (“eGFP level”)
Top = maximal sfGFP level [au] (eGFP level at “full induction”)
Bottom = minimal sfGFP level [au] (“leakiness”)
n = Hill coefficient (“cooperativity”)
EC₅₀ = Half-maximal effective concentration (“sensitivity”)

Liquid culture and agar plate OHHL detection comparison

To gain precise data out of our fluorescence analysis, to better characterize the different promoters, we use the single analysis to obtain high throughtput data.
The protocol was the following :
From overnight cultures we inoculate 50 mL Falcon™ tubes containing 5mL LB media, 5 uL OHHL and the antibiotic. We evaluate a range of 10 different concentrations from
10^-4nM OHHL to 10⁵nM OHHL by a 10 fold increase, according to the results of the plate reader analysis. The measurements were done in duplicates.

In liquid culture

The direct plot of both sensivity curves shows the clearly shifted sensivity of the pLuxR1 promoter in comparison to the wild type R0062 promoter. The EC₅₀ shit from 0.02nM for the wild type to 6'250 nM for the pLuxR1 promoter is equal to a 312'500 fold increase.
This promoter will be used in our final set-up to only respond to high concentrations of OHHL and therefore be activated, when two sender cells are surrounding the receiver cell, and expressing the AES hydrolase responsible for the colorimetric conversion of the specific substrate to a visible purple output.

Figure 4. Comparison of the Wild Type and PluxR1 mutant sensitivity curves in liquid culture using the BD LSRFortessa™ Flow Cytometer System
For the wild type :EC₅₀=0.02nM, R²=0.84, n=1.7
For G1 we got :EC₅₀=6482nM, R²=0.97, n=0.8

On agar plates

For the real colisweeper game we need to know about the behavior of the promoters on agar plates.
We set-up an experiment which consists in pooring agar plates containing different OHHL concentration going form 10^-5nM to 10⁵nM by 10 fold increase. The wild type and the pLuxR1 promoter were streaked onto those plates to analyze the sensivity to OHHL of the wild type and the promoter on an agar plate. After 15hours of incubation at 37 degree celsius some colonies were picked and resuspended in Phosphate Buffered Solution (PBS) for the single cell analysis , using again the BD LSRFortessa™ Flow Cytometer System.

Figure 5: Sensitivity curve of the Wild Type on agar plates and liquid culture For the liquid culture we got :EC₅₀=0.02nM, R²=0.84, n=1.7; For the agar plates we got :EC₅₀=4.45nM, R²=0.80, n=1.7

Figure 6: Sensitivity curve of the G1 on agar plates and liquid culture
For the liquid culture we got :EC₅₀=6482nM, R²=0.97, n=0.8;
For the agar plates we got :EC₅₀=17814nM, R²=0.93, n=0.8

</p>

We thank our sponsors: