Team:ETH Zurich/Experiments 6

From 2013.igem.org

(Difference between revisions)
Line 3: Line 3:
<h1>GFP diffusion tests with sender cells and wild-type P<sub>LuxR</sub> receiver constructs</h1>
<h1>GFP diffusion tests with sender cells and wild-type P<sub>LuxR</sub> receiver constructs</h1>
-
[[File:Circuit_GFP_Coliseeper.png|left|100px|thumb|<b>Figure 1: </b> Experimental setup for Colisweeper with GFP.]]
+
[[File:Circuit_GFP_Coliseeper.png|left|150px|thumb|<b>Figure 1: </b> Experimental setup for Colisweeper with GFP.]]

Revision as of 21:49, 28 October 2013

Header2.png
80px-Eth igem logo.png

GFP diffusion tests with sender cells and wild-type PLuxR receiver constructs

Figure 1: Experimental setup for Colisweeper with GFP.


Diffusion experiments were performed to study AHL diffusion from the sender colonies to the receiver colonies. The sender receiver ciruit is shown in the figure to the left. The sender colonies consist of the luxI ([http://parts.igem.org/Part:BBa_K805016 BBa_K805016]) producing AHL under a constitutive promoter. The luxI produces AHL that diffuses through the agar. The diffused AHL reaches the non-mine and is processed via promoter part [http://parts.igem.org/Part:BBa_J09855 BBa_J09855] cloned with GFP was used as our receiver. The presence of GFP in the receiver colonies is then co-related to the amount of AHL processed by the receiver colonies.




Figure 2: Schematic diagram of placement of sender receiver colonies in the hexagonal grid with one, two and three mines.

The picture on the left shows the scanned image of GFP fluorescence after 11 hours of incubation. The green circles mark the mine colonies. The receiver colonies are those that process the AHL that diffused from the sender colonies. The difference in fluorescence in the receiver colonies correlates directly to the number of adjacent mine colonies. The data from this experiment shows almost complete agreement with the spatio-temporal model.






</p>

Figure 2: Quantitative data of the relative GFP fluorescence in a receiver colony surrounded by one (green line), two (red line) and three (blue line) mine colonies over time.

The graph on the right shows the relative intensity of the GFP signal in the receiver colonies with one, two and three adjacent mine colonies at different timepoints. All scanned images of the plate similar to the one depicted above were analyzed using the image processing program ImageJ. The GFP fluorescence reaches saturation after 11 hours of incubation at 37℃ . Due to the presence of more mine colonies, more AHL molecules are processed by the non-mine and higher fluorescence can be observed. Three adjacent mines lead to the highest value of fluorescence compared to two or one adjacent mine colonies. This data is qualitatively similar to the model, but GFP expression is quantitatively different in comparison to the model.


GFP diffusion tests with sender cells and mutated PluxR promoter receiver constructs

Figure 3: Scanned image of GFP fluorescence in a hexagonal grid with sender cells in green and mutant pLux GFP receiver cells


Also the mutant promoter [http://parts.igem.org/Part:BBa_K1216007 BBa_K1216007] we obtained through site-saturation mutagenesis was tested in the hexagonal grid experiment with LuxI sender cells. The sensitivity for AHL (EC50=12'555 nM) was very low and only in the case where three mines surround a receiver colony some fluorescence could be observed. Still the results are consistent with the model predictions and led to the rational design of additional promoter mutants, where either one of the two point mutions was changed back with the goal to recover some of the sensitivity of the wild type.

Figure 4: Sequence of the wild type pLuxR promoter and the tested variant.